+27 11 886 0307 | +27 11 789 3913 | info@dynamicid.co.za
Slide background

DURAFLEX ULTRA HT
SPECIFICATION SHEET

Download PDF

DURAFLEX ULTRA HT 

FACESTOCK 

  • 2 mil polyimide film withstands intermitted heat up to 398° and endures wave solder and standard acidic solvent.
  • Tested and approved for leaded and non-leaded reflow – top and bottom; wave solder – top preferred
  • Super smooth topcoat allows for printability up to 600 DPI for high –density barcodes such as data matrix codes with consistent ANSI scannability.
  • Topcoat has static dissipating properties that minimize the risk of print voids.
  • Thermal Transfer Printable

ADHESIVE 

  • Permanent pressure sensitive adhesive bonds well to standard PCB’s
  • Low outgassing of adhesive.

LINER 

  • Available on a variety of liners to meet your specific application and dispensing requirements

PERFORMANCE 

  • The printed surface should not be touched while hot. The resin TTR will be soft and smudge.
  • We recommend exposing printed labels to high heat prior to preforming tests.
  • All surfaces should be clean, dry and free of any surface contamination. IPA is the recommended cleaning solution.

CONVERSION PRINTING

  • Service temp range from 260°C intermitted to 398°C for every 5 min
  • Minimum application temperature 18°C

SHELF LIFE

  • Two years when stored at 21°C with 50% relative humidity

STATEMENT OF PRACTICAL USE

  • Test data is based on laboratory test structure. Actual application testing should be done to confirm suitability for application.